It is not a bad idea to install a new intake manifold gasket on your Chevy 350. In fact it is one way to make its overall performance much better. We also understand that you might not be aware of how to go about it, and that is what we are here to help you with.
This write up will be focused on how you can remove and install the intake manifold gasket on a Chevy 350.
How To Remove & Install Intake Manifold Gasket Chevrolet 350
Remove the Air Cleaner
The first thing is to remove the air cleaner if your Chevy 350 has one. This is the first thing to do before you can install the intake manifold.
To remove the air cleaner, what you have to do is to unscrew the screws that hold down the air cleaner to the intake manifold. After you are done with this, proceed to remove the intake manifold from the engine block using a screw driver.
You have to be careful while doing this so that you don’t end up damaging the engine block.
Disconnect the Fuel Lines
The next step is to disconnect the fuel lines and there are different ways through which you can do this. The very popular method of doing this is by using a fuel line disconnect tool.
A fuel line disconnect tool is a small, hand-held device that comes with a claw-like grip on one end and a cut-off wheel on the other.
The cut-off wheel is what you will use to slice through the fuel line, while the claw-like grip is what you will use to draw it out of the fuel pump.
Another method that you can use to disconnect the fuel lines is to make use of a fuel line wrench. A fuel line wrench is a tool with a ratchet handle and a long thin bolt. You can use it to twist the fuel line off the fuel pump.
Disconnect the Vacuum Lines
To remove and replace intake manifold Gasket, you will have to disconnect the vacuum lines especially if you have a 4.3L or 5.3L engine.
Disconnect the Spark Plugs
Also bear it in mind that you will have to disconnect and replace the spark plugs.
Remove the Intake Manifold
We are almost done with the steps you have to take to remove and install the intake manifold gasket in your Chevy 350. After you have completed all the steps that we have already discussed, what is left for you to do is to remove the Intake Manifold.
To do this, you have to remove the four bolts that hold down the manifold to the engine block. When you are done removing the bolts, you can then proceed to remove the intake manifold gasket.
Install the New Intake Manifold Gasket
When you are done removing the gasket the next thing to do is to replace it with another one. Ensure that you have properly and completely removed the old gasket before bringing in the new one. Properly position and secure the new gasket.
Now that you are done reading, there is no doubt that you now know how to go about removing and replacing the intake manifold gasket. You can still go through it again if you need more clarification.
